Top Brake Motorcycle Travel Tire Repair Kit

Instruções:
1. Marque a posição onde o pneu precisa ser reparado e retire o furo.
2. Use o cone espiral para determinar a direção da ferida, coloque cola na frente do cone espiral e insira Insira e retire a ferida por mais de três vezes para preencher a ferida com agente vulcanizante
3. Insert the tire repair rubber strip into the front port of the tire repair pin in a half on one side
That is, all the drawings of the two sides of the vulcanized rubber strip, gluing, plug-in, and plugging to the end
4. Pull out slowly, and stop when pulling out the rubber strip for 1cm, when there are four rubber strips in the holestate
5. Cut off the rubber strip and leave it 2mm higher than the tread
6. Test with water. If there is air leakage, add another one along the edge as per 3 and 4

Matters needing attention:
This tire repair tool is applicable to the repair of punctures below 6mm of the vacuum tire nail hole. The tire pressure should be lower than 1.5 during the repair, otherwise the film is easy to break. Do not look directly at the injury hole during the operation to prevent gas or foreign matter from spraying. Wear goggles for construction.

Packing list:

1Set：Kit de reparo de pneu * 1Set
ou
2Set：Kit de reparo de pneu * 1Set
Mangueira de ar * 1
ou
3Set：Kit de reparo de pneu * 1
Cola * 1
Tira de borracha * 1
ou
4Set：Mangueira de ar * 1